Armstrong

The Armstrong Foil Kit Carry Bag.

Carry your foil around in a big bag so all your friends know you are a foiler and are going foiling. Medium for 75cm masts/wings and shorter, Large for 85cm masts/wings and longer with a zip so the end can stick out.

Set of 4 Titanium T Nuts, Bidirectional Titanium washers with Torx head stainless steel 316L screws

Attention to design and detail is what sets Armstrong apart! We are committed to using the very best materials for each respective job, this is why we use Titanium and Stainless steel 316L for our hardware and fittings. Ultimate strength and no corrosion means your mast to board connection is dependable.

* We recommend changing out your screws annually as repeated use will eventually reduce their strength.

Armstrong Shim TTF (Titanium Trim Fairings) Our state of the art rear wing configuration incorporates an easy to change, honeycomb Titanium Trim Fairings that allow you to fine tune the angle of the Tail Wing to your personal requirements. The TTF sets the angle of attack of the tail wing. We use -2 degree, Zero degree and +1 degree trim options. The TTF works in conjunction with changing the front wings, fueslarge length and your required use and feeling.

-2 Degree: Ideal for learning, heavier riders, larger boards and windsurf freeride. Tail has more down force giving front wing more lift at lower speeds and better Yaw (directional) stability.

Zero Degree: Ideal for all round progression.

+1 Degree: More top end speed and control, better pump for advanced riders looking to maximise glide. During a drop or speed spike the +1 helps keep the wing in the water and adds control during turns.

Made to be as light as possible AND super comfy - with our new pressed memory foam, they come with our Titanium washers and 316L screws. Price is for 1 Footstrap.
When fitting, it's important that the washer is properly tightened. The memory foam needs to be fully compressed. Our Titanium hex washer is designed with a recessed underside to press into the memory foam and clamp the straps internal webbing to the board.

Make sure you do these up tight. The Washer needs to be the strength point.
The washer outline and recesses should be imprinted into the memory foam if removed.

Armstrong foil screw set. Comes with all the screws and barrel nuts needed to assemble the fuselage and wings. T Nuts that mount the foil to the board are not included.

Comes with:

Polycarbonate Pro Shims (PPS), allowing more than 5 angle settings at 0.5 degree increments.

The set includes: 2 X Dome Head Screw 19.5mm, 2 x 0.5° PPC Shims, 2 X 1° PPC Shims, 5 X Countersink Screw 28.5mm, 4 X Dome Head Screw 25mm, 2 X 8mm Custom Ti Barrel Nut, 1 X T30 Bit

Set of 4 Titanium T Nuts with Torx head Ti screws, with countersunk heads.

Attention to design and detail is what sets Armstrong apart! Armstrong uses the very best materials for each respective job, this is why we use Titanium for their hardware and fittings. Ultimate strength and no corrosion means your mast to board connection is dependable.

* We recommend changing out your screws annually as repeated use will eventually reduce their strength.

25MM or 30MM length Screws